Edimax Technology EW-7711UAN, EW-7711UMN manual

Page 48

You can also set ‘Config Mode’ to ‘Registrar’. In this mode, this wireless network card will wait for other WPS-enabled access points to send WPS pairing requests. Please refer to the instruction given by your wireless access point’s user manual to understand how to send WPS requests.

4.Before you start to establish the wireless connection by using WPS, you can click ‘Rescan’ button to search for WPS-enabled access points near you again, to make sure the WPS function of your access point is activated.

All access points with WPS function enabled will be displayed here. Please make sure the access point you wish to connect is displayed. If not, please click ‘Rescan’ few more times. You can also click ‘Information’ button to see the detailed information about selected access point.

5.Start PBC pairing procedure at access point side (please refer to the instruction given by your access point’s manufacturer), then click ‘PBC’ button in wireless configuration utility to start to establish wireless connection by WPS. Please be patient (This may require several seconds to one minute to complete). When you see ‘WPS status is connected successfully’ message, means the connection between this wireless network card and access point is successfully established by WPS, and the information about access point you connected to will be displayed.

6.You can click ‘Detail’ button to see detailed information of connected access point. If you wish to save this connection as a profile, you can click ‘Export Profile’ button, and this connection will be saved. You can find this connection in ‘Profile’ tab in a later time.

7.Sometime WPS may fail (In the following picture, WPS pairing is failed because no WPS-enabled access point is found):

44

Image 48

Contents Page Page T a L O G Chapter IV Appendix………………………………………………………………62 Introduction and safety information Main FeaturesSafety Information Chapter I Product InformationPackage Contents System RequirementsFamiliar with your new wireless network card DescriptionChapter II Driver Installation and Configuration Network Card InstallationUnder Windows XP Under Windows Vista Page Page Page Here Page Connect to Wireless Access Point Using Edimax Utility Page Scan for Other Wireless Devices AB C DE Page Item Name Description Connect to an Access Point Page Page Page Add an Access Point to Profile Here are descriptions of every setup item Item Name Description WPA Select 802.1x EAP method from dropdown menu. Please ask ‘Remove’ Using Windows Zero Configuration Page Page Page Profile Management Add a profile Edit an existing profile Delete an existing profile Activate a profile Advanced Settings Here are descriptions of every setup item View Network Statistics WMM Setting Check this box to enable WMM function. Please click ‘Apply’ WPS Configuration WPS Setup PBC Push-Button Configuration WPS Button Push-ButtonPage Page WPS Setup PIN Page Radio On/Off About On-line Help Switch to AP Mode and Basic Configuration Chapter III Soft-AP FunctionPage Please input the Ssid the name used to identify Are in different country. For example when Be operated. Selection of other channels is notPermitted under FCC regulations Security Setting Please select a wireless authentication type you wish to use Access Control Select the policy type of your access rule Connection Table AIDEvent Log Statistics Chapter IV Appendix Specification Troubleshooting List What is the Ieee 802.11g standard? What is the Ieee 802.11b standard?Glossary What does Ieee 802.11 feature support? What is Ad-hoc?What is Infrastructure? What is BSS ID?What is TKIP? What is AES?Can Wireless products support printer sharing? What is DSSS? What is FHSS? And what are their differences? What is Spread Spectrum?What is WMM Power Save? What is WMM?What is STBC? What is WPS?What is GI? Federal Communication Commission Interference Statement 4FCC and CE Compliance StatementsPage TTE Compliance Statement