Furuno DP-6 manual Editing/Deleting Timer Programs

5.Press the [ ] key to advance the cursor to the Start Time line. Enter start time in 24-hour notation. To have the operation start at 8:35, for example, the keying sequence would be;

[0][8] [3] [5] [0] [0]

6.Press the [ ] key to advance the cursor to the Stop Time line. Enter stop time.

7.Press the [ ] key to advance the cursor to the Receive/Send line. Select operation category; Receive or Send.

8.For send, insert floppy disk in drive and designate the file to send. Press the [ ] key to advance the cursor to the File to Send line. Press the [ ] key to display the file list, select a file, and press the [Enter] key.

9.Press the [Enter] key.

10.Press the [Enter] key. The operation name appears in the Timer Operation List. See note 2 and 3.

Note 1: To change a timer program, select it on the Timer Opera- tion List, select Change and press the [Enter] key. Enter new data.

Note 2: If the operation name entered already exists, the display

shows the following message: Operation name already exists. Press any key to escape. Press any key and change the operation name.

Note 3: If the station name entered has not been registered, the

display shows the following message: Station by that name does not exists. Press any key to escape. Press any key and register the station as shown on page 3-3.

Editing/Deleting Timer Programs

1.Press function key [F5] and the [2] key.

2.Select timer program from the Timer Program List.

3.Select Change and press the [Enter] key.

4.Do one of the following;

Edit program: Use [ ], [ ] and the [Backspace] key to make corrections.

Delete program: Erase operation name with the [Backspace] key.

5.Press the [Enter] key twice.

6.Press the [Esc] key.

3-6