Carrier Access Adit 3104 user manual Web-Based Management, To access the management console

Configuration

Web-Based Management

Web-Based Management

The web-based management interface allows you to control various system parameters. The interface is accessed through a web browser.

To access the management console

NOTE: The following assumes that you have connected the PC to the LAN port of the Adit 3104.

1.Launch a web browser on your PC in the LAN to which the Adit 3104’s LAN port is connected. Note: If connection to the Adit 3104 is to be through an Ethernet or T1 WAN, the remote admin WAN access must be enabled with the following command sequence:

Command	Description
Username: admin	Log into the system (username and password).
Password: ********
Adit 3104> enable	Enter the Privileged mode.
Password: ********	Enter password for the Privileged mode.
#configure terminal	Enter the Configuration mode.
(config)# remote-admin web	Enable remote web admin.
primary-port enable

2.Type the Adit 3104’s IP address or name in the address bar. Example: http://192.168.1.1.

Default IP address is http://192.168.1.1

Note: To display the current IP address of the systems, use the following CLI command: #show interface ethernet 1 (LAN)

#show interface ethernet 2 (Eth WAN)

3.Login to the unit.

Enter User Name and Password. Note: These setting should be changed from the default settings after the initial login.

Default user name is admin

Default password is admin 123

NOTE: After a few minutes of inactivity, the session will automatically timeout and the operator will be required to log in to continue the session.

WARNING! IF YOUR USER NAME AND PASSWORD ARE SET TO THE DEFAULT SETTING, IT IS RECOMMENDED THAT YOU MODIFY THEM FOR SECURITY PURPOSES.

4-4 Adit 3104 - Release 1.6