Datalogic Scanning Understanding Junction Box Electrical Connections for Datalogic DS2400

DATALOGIC DS2400

2.3.2 Junction Box Electrical Connections

The connection and wiring procedure for Junction Box is described as follows:

1)Open the junction box by unscrewing the 4 cover screws.

2)Pass all System cables through the glands in the junction box housing.

3)To connect the power and input/output signals:

∙Prepare the individual wires of the system cables by stripping the insulation back approximately 11 mm.

∙Using a device such as a screwdriver, push down on the orange lever directly above the clamp (see Figure 2.6).

∙Insert the wire into the clamp and release the lever.

The wire will now be held in the spring clamp.

Figure 2.6 - System cable connections to the junction box

The wiring used can be solid or stranded but must meet the following specifications:

Positions 1-4:	24 - 16 AWG	0,2 - 1,5 mm2
Positions 5-39:	26 - 20 AWG	0,14 - 0,5 mm2

The junction box pinouts are indicated in the following table:

Installation - 2.5