Setting A Single Character Prefix or Suffix
To set one ASCII character as a prefix or suffix, follow steps one through
four on the previous two pages (select prefix or suffix), then...
1. Scan the two digit Hex Code for that character. (e.g. 03, 8F, ...FF)
NOTE
If you make a mistake, or lose your place while setting this option, scan the END label to exit Programming Mode. The scanner will sound an error tone (six rapid beeps) to indicate that programming was incomplete, and the setting will remain as it was before entering Programming Mode.
2. Scan the ONE CHARACTER ONLY label on the following page.
3. Scan the END label.
You have set a single character prefix or suffix.
Setting Prefix and/or Suffix Characters
NOTE
You must scan the SET label and either the SET PREFIX or SET SUFFIX label before using the labels on this page.
0
1
2
3
4
5
36 | QuickScan 6000/6000 Plus |