Datalogic Scanning GM4100 manual Insert the cover in the handle and screw it back into place

Page 15

Setting Up the Reader

3.Carefully lift out the gold contacts circuit, and remove the battery holder while letting the white connector pass through the hole in the battery holder (as shown in the picture below).

Pass-through hole

4.Remove the old battery from its place (if present), and insert the new battery in the same position.

5.Replace the battery holder, plug in the connector and return the contacts circuit to its previous location.

When inserting the new battery into the handle, take care to position the battery and the connector as shown.

NOTE

6.Insert the cover in the handle and screw it back into place.

Quick Reference Guide

11

Image 15

Contents Gryphon I GM4100 Datalogic Scanning, Inc Table of Contents Page FCC Class B Compliance Statement Statement of Agency ComplianceCanadian Notice Gryphon Product Series END User License Agreement Intellectual Property Limitation Of Liability Customers Under Software Support Software Product PolicyBattery Safety Setting Up the ReaderSerious injury Do not replace the battery pack when the device is turned on Connector Install the BatteriesInsert the cover in the handle and screw it back into place Changing the Base Station Position Configuring the Base StationTab Securing the DC Power Cord Optional Connecting the Base StationOptions for routing the DC cord Connecting to the Host System and Network Layouts RF DevicesStand Alone Layouts Multiple Reader Layout Base LEDs Using the BC40xx Radio BaseUsing the Programming Barcodes ProgrammingDisplay Select the Interface Type Configure Other SettingsInterface Selection Configuring the InterfaceIBM Keyboard Keyboard Wand Emulation Scancode Tables Country ModeStandard Factory Settings Keyboard InterfaceCountry Mode Country Mode Country Mode Country Mode Caps Lock State Numlock Description Technical Specifications15% minimum reflectance Regulatory LED Beeper LED and Beeper IndicationsReader Number Error CodesIndication Leds Base Station IndicationsPower Supply Ergonomic RecommendationsRegulatory Information Imager Labeling Weee Statement Exclusions WarrantyWarranty Quick Reference Guide Warranty Declaration of Conformity Italy