Datalogic Scanning GM4100 manual Interface Selection, Configuring the Interface

Page 26

Interface Selection

Interface Selection

Each reader model will support one of the following sets of host interfaces:

General Purpose Models: RS-232,RS-232 OPOS, USB, Key- board Wedge

Retail Point of Sale Models : RS-232,RS-232 OPOS, USB, IBM 46XX

Configuring the Interface

Scan the programming barcode which selects the appropriate in- terface type matching the system the reader will be connected to.

Next, proceed to the corresponding chapter in the Gryphon™ I GD4100/GM4100 PRG to customize any settings and features associated with that interface.

Unlike some other programming features and options, interface selections require that you scan only one programming barcode label. DO NOT scan an ENTER/ EXIT barcode prior to scanning an interface selection barcode.

Some interfaces require the scanner to start in the dis-

NOTE abled state when powered up. If additional scanner configuration is desired while in this state, pull the trigger and hold for 5 seconds. The scanner will change to a state that allows programming with barcodes.

RS-232

RS-232 standard interface

Select RS232-STD

RS-232 Wincor-Nixdorf

Select RS232-WN

22	Gryphon™ I GM4100

Image 26

Contents Gryphon I GM4100 Datalogic Scanning, Inc Table of Contents Page Statement of Agency Compliance FCC Class B Compliance StatementCanadian Notice Gryphon Product Series END User License Agreement Intellectual Property Limitation Of Liability Software Product Policy Customers Under Software SupportSetting Up the Reader Battery SafetySerious injury Do not replace the battery pack when the device is turned on Install the Batteries ConnectorInsert the cover in the handle and screw it back into place Configuring the Base Station Changing the Base Station PositionTab Connecting the Base Station Securing the DC Power Cord OptionalOptions for routing the DC cord Connecting to the Host Stand Alone Layouts System and Network LayoutsRF Devices Multiple Reader Layout Using the BC40xx Radio Base Base LEDsDisplay Using the Programming BarcodesProgramming Configure Other Settings Select the Interface TypeConfiguring the Interface Interface SelectionIBM Keyboard Keyboard Wand Emulation Keyboard Interface Country ModeStandard Factory Settings Scancode TablesCountry Mode Country Mode Country Mode Country Mode Caps Lock State Numlock Technical Specifications Description15% minimum reflectance Regulatory LED and Beeper Indications LED BeeperReader Error Codes NumberBase Station Indications Indication LedsRegulatory Information Power SupplyErgonomic Recommendations Imager Labeling Weee Statement Warranty ExclusionsWarranty Quick Reference Guide Warranty Declaration of Conformity Italy