Datalogic Scanning GM4100 manual Select the Interface Type, Configure Other Settings

Page 25

Programming

Select the Interface Type

Upon completing the physical connection between the reader and its host, proceed directly to Interface Selection on page 22 for in- formation and programming for the interface type the reader is connected to (for example: RS-232, Keyboard Wedge, USB, etc.) and scan the appropriate barcode to select your system’s correct interface type.

Configure Other Settings

Additional programming barcodes are available in the Gryphon™ I GD4100/GM4100 PRG to allow for customizing programming features. If your installation requires different pro- gramming than the standard factory default settings, refer to the PRG.

Resetting Standard Product Defaults

If you aren’t sure what programming options are in your reader, or you’ve changed some options and want the factory settings re- stored, scan the Standard Product Default Settings barcode below to copy the factory configuration for the currently active interface to the current configuration.

Factory defaults are based on the interface type. Con- figure the reader for the correct interface before scan- ning this label.

NOTE

Standard Product Default Settings

Quick Reference Guide

21

Image 25

Contents Gryphon I GM4100 Datalogic Scanning, Inc Table of Contents Page FCC Class B Compliance Statement Statement of Agency ComplianceCanadian Notice Gryphon Product Series END User License Agreement Intellectual Property Limitation Of Liability Customers Under Software Support Software Product PolicyBattery Safety Setting Up the ReaderSerious injury Do not replace the battery pack when the device is turned on Connector Install the BatteriesInsert the cover in the handle and screw it back into place Changing the Base Station Position Configuring the Base StationTab Securing the DC Power Cord Optional Connecting the Base StationOptions for routing the DC cord Connecting to the Host RF Devices System and Network LayoutsStand Alone Layouts Multiple Reader Layout Base LEDs Using the BC40xx Radio BaseProgramming Using the Programming BarcodesDisplay Select the Interface Type Configure Other SettingsInterface Selection Configuring the InterfaceIBM Keyboard Keyboard Wand Emulation Standard Factory Settings Country ModeKeyboard Interface Scancode TablesCountry Mode Country Mode Country Mode Country Mode Caps Lock State Numlock Description Technical Specifications15% minimum reflectance Regulatory LED Beeper LED and Beeper IndicationsReader Number Error CodesIndication Leds Base Station IndicationsErgonomic Recommendations Power SupplyRegulatory Information Imager Labeling Weee Statement Exclusions WarrantyWarranty Quick Reference Guide Warranty Declaration of Conformity Italy