Connect Tech CTIM-00060 user manual Hardware Installation, Standard computer

Page 16

Connect Tech Inc. FreeForm/Express S6 - PCIe Spartan-6 FMC Carrier User Manual

Hardware Installation

Standard computer

1.Ensure all computer power supplies are off and disconnected (remove AC line cord)

2.Install the FMC module, if required.

3.Verify all jumper settings from the relevant sections

4.Install the necessary cables for the application.

WARNING: Do not plug the FreeForm/Express S6 into a PCIe slot with an external power source connected to P1. This could lead to board damage and void the product warranty.

5.Install the FreeForm/Express S6 module into x1 PCIe slot.

6.Connect the appropriate interface cables to the FMC bracket I/O.

7.Connect the computer’s AC line cord to the computer’s power supply.

8.Turn on the computer system.

Revision 0.01

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents FreeForm/Express S6 Table of Contents Customer Support Overview Contact InformationLimited Lifetime Warranty Copyright NoticeTrademark Acknowledgment Revision HistoryWhat is an Fpga Mezzanine Card FMC? FeaturesIntroduction System Block Diagram Hardware Description PCI Express BusMemory & Flash Low Pin Count FMC InterfaceConnector PGC2M CLK1M2CP PRSNTM2CL Configuration Connector & LEDs EthernetFunction Ethernet Status LEDs Locations Power SerialHardware Installation Standard computerCables & Interconnect Mating ConnectorsMating Cables Fpga Design MIGSignal Name Pin Name IO Standard Bank Fpga PinoutIOL46PM3CLK3 DIFFSSTL15II LVDS25 AB4 IOL4NVREF2 LVDS25 MGTTXN0101 X1SPICLK Specifications Fpga
Top Page Image Contents