Boulder Amplifiers 865 manual Setting the Boulderlink Switch

Page 15

SETTING THE BOULDERLINK SWITCH

The normal setting of the MASTER / SLAVE switch is MASTER.

When using the 865 with only power amplifiers, the Boulderlink MASTER / SLAVE switch should be set to MASTER.

For more information on Boulderlink, see the Boulderlink section 5-1 as indicated by the finger tab below.

1-9

GETTING

STARTED

Image 15

Contents Page Boulder Integrated Amplifier Page Table of Contents Remote Control Recording Getting Started IntroductionQuick Start Placement of the 865 Integrated Amplifier Connecting to the Mains Outlet Polarity Connecting a Balanced Analog SourceConnecting AN Unbalanced Source Connecting the Auxiliary Outputs Getting Started Connecting Your Loudspeakers Setting the Boulderlink Switch Operation Powering UPInput Selections Volume Balance Mute Display Batteries Remote ControlSource Selection VOLUME, Balance and MuteInput Names ProgrammingProgramming Input Level Calibration Input Balance Calibration Start Volume Theater ModeProgramming by the Display Button Auxiliary Outputs ModeBoulderlink ID Remote IDBoulderlink Speed Reset to Factory Defaults Boulderlink Connecting BoulderlinkBoulder Link Setting Boulderlink ID Numbers Setting Boulderlink SwitchesPower UP VIA Boulderlink Boulder Link Boulderlink Messages Boulder Link Recording Connecting a Recording DeviceAppendix Boulder 865 Integrated Amplifier Specifications Troubleshooting Symptom Cause Remedy Appendix