System. You

on the on the

SKIP/SEARCH

13-1291.fm Page 26 Wednesday, July 14, 1999 6:29 PM

(illus)

The CD display shows the disc number you entered in Step 2 and the track number (next to P) you entered in this step. The CD changer programs your selection.

Note: If the track number you entered disappears before you press TRACK, repeat Steps 2–3.

4.Repeat Steps 2–3 to program more selections.

Note: You must re-enter the disc number in Step 2 even if you pro- gram more than one track from the same disc.

5.To play the programmed sequence, press PLAY/PAUSE on

the front of the system or on the remote control. After a few

seconds, appears on the CD display, and the first programmed track on the first programmed CD begins to play.

To play the previous track or the

next track in the programmed sequence, press

system or or remote control.

You can use audible search dur- ing programmed play by press- ing and holding down SKIP/


SEARCH				or

	on	the	system. You


cannot use		or		on the

remote control to do audible search.

Note: When the CD changer reaches the beginning of a track during audible search, it pauses there.

6.After the CD changer plays the last track in the programmed sequence, it stops automatically.

You can also press STOP on

the system or on the remote control to stop the programmed sequence.

Caution: Do not press STOP

on the system or on the remote control more than once. Doing that clears the programmed sequence.

Notes:

•If you programmed a non-existent track (for example, Track 10 when that CD has only nine tracks), the CD changer skips the track and plays the next programmed track.

•The programmed sequence stays in memory after playback is over. See “Clearing the Programmed Sequence” on Page 27 for how to clear the programmed sequence.