All connections are made on the rear panel of the modem as shown below.
Note: You must give the Cable Modem MAC and Ethernet Adapter addresses to your cable company before you connect the modem. See page 5.
Cable and Power Connections
1 | Turn your computer on. |
2 | Connect one end of the 10BaseT/Ethernet cable to the 10BT |
| jack on the rear of the modem and the other end to the |
| 10BaseT jack on your computer. |
3 | Connect the coaxial cable to the cable jack on your wall. (If |
| you are using a splitter, follow the directions on page 21.) |
| Connect the other end of the cable to the cable connector on |
| the back of the modem. |
4 | Insert the small round end of the power cord into the power |
| socket on the back of the modem. Plug the power adapter into |
the wall socket. The READY and 10BT lights on the front panel come on.
The cable modem now starts the synchronization process described below.
Automated Synchronization
The lights on the front panel (see above) indicate the status of the synchronization process.
Installing Your Cable Modem | 23 |