Avaya M-ACCF/SF manual Commands Tree Chart, Logging On

Chapter 4 X-Switch CLI & ATM Terminal Interface

ATM Access Module Terminal Interface for Configuring ATM Parameters

To use this terminal interface you must connect the terminal to the ATM Access module Console port or start a Telnet session to the ATM module IP address.

You can establish a connection only after the ATM module has an IP address and connectivity to the server. Use the M-ACC CLI to perform these two prelimiary tasks (see the Section, X-Switch Command Line Interface (CLI)51).

Commands Tree Chart

Figure 4.1 shows a chart of available local management screens.

Logging On

1To begin a Telnet session, open it to the ATM access module IP address. You will be prompted by the following:

ATM Access Module

Select access level (read, write, admin):

2Type in your access level followed by your password. Note that they are both case-sensitive:

—If you are logging on for the first time (after installation or initialization), use a default user name and password to match your access requirements and privileges, in accordance with Table 4.1.

—If you have been assigned a user name, access level and password, type in these details.

Table 4.1	Users and their Privileges
User Type		Access Level/	Privilege
		Default Password
junior		read	Read but not Write
operator
senior		write	Read and Write
operator
administrator		admin	Read, Write and can change passwords

58 Avaya M770 M-ACCF/SF ATM Access Modules User’s Guide