Avaya M-ACCF/SF manual Establishing a Telnet Session, For example telnet

Chapter 3 Installation

The RJ-45 port on the front of the module is labeled “Console”, and may be used to configure the switch using the built-in Command Line Interface (CLI, Terminal Emulation). In the future, this connector will also be used for out-of-band SNMP management, via a modem.

The port settings are as follows:

•Baud Rate - 9600 bps

•Character Size - 8

•Parity - None

•Stop Bit - 1

•Flow Control - None

•We recommend using a VT-100 terminal to enable access to all CLI features.

The terminal connected to the serial port must be configured with the same settings; this setting will work with any PC COM port over a DB9 to RJ45 connector.

Establishing a Telnet Session

1Connect your PC to the network

2Verify that you can communicate with the Avaya M770 M-SPX/S using Ping to the IP of the M-SPX/S. If there is no response using Ping, check the IP address and default gateway of both the M-SPX/S and the PC.

3From the Microsoft Windows® taskbar of your PC click Start and then Run (or from the DOS prompt of your PC), then start the Telnet session by typing: telnet <M-SPX/S_IP_address>

For example: telnet 149.49.32.112

Note: One of the possible reasons that you cannot establish a Telnet session to the M-SPX/S, may be because there is already a session in progress.

4When you are prompted for a Login Name, enter the default name super

5When you are prompted for a password, enter the password super in lower case letters (do NOT use uppercase letters).

6The Switch Main Menu displays.

7When you choose Option 1 and enter the M-ACC slot number, you reach the M-ACC’s Setup Main Menu.

8You can now configure the M-ACC module and change its default IP address.

44 Avaya M770 M-ACCF/SF ATM Access Modules User’s Guide