Avaya 2600, 5400ZL, 3500YL manual Configure the ProCurve 5406zl Switch, Media Parameters

All network components are in network region 1 for this sample configuration. The DiffServ and 802.1P/Q values configured here will be downloaded to the Avaya H.323 IP telephones via Avaya Communication Manager. Avaya SIP IP telephones will get QoS settings by downloading the 46xxsettings file from the HTTP server. For more information on QoS settings, please refer to [1].

Use the change ip-network-region 1 command to change the DIFFSERV/TOS PARAMETERS and 802.1P/Q PARAMETERS settings configured in Avaya Communication Manager. Set the Call Control PHB Value to 46 and the Audio PHB Value to 46. Set the Call Control 802.1p Priority and Audio 802.1p Priority to 6.

change ip-network-region 1		Page	1 of 19
Region: 1		IP NETWORK REGION
	Authoritative Domain: devcon.com
Location:
Name:		Intra-region IP-IP Direct Audio: yes
MEDIA PARAMETERS
Codec Set: 1		Inter-region IP-IP Direct Audio: yes

UDP Port Min: 2048			IP	Audio Hairpinning?	y
UDP Port Max: 3027			RTCP	Reporting Enabled?	y
DIFFSERV/TOS PARAMETERS
Call Control	PHB Value: 46		RTCP MONITOR	SERVER PARAMETERS	y
Audio	PHB Value: 46		Use Default	Server Parameters?
Video	PHB Value: 26
802.1P/Q PARAMETERS		Priority: 6
Call Control	802.1p
Audio	802.1p	Priority: 6	AUDIO RESOURCE RESERVATION		PARAMETERS
Video	802.1p	Priority: 5

H.323	IP ENDPOINTS		RSVP Enabled? n
H.323 Link Bounce Recovery?			y
Idle	Traffic	Interval (sec):	20
Keep-Alive		Interval (sec):	5

Keep-Alive Count: 5

The Differentiated Services Code Point (DSCP) value of 46 is used for both PHB values. DSCP 46 represents the Traffic Class of Premium and the Traffic Type Voice.

Note: The PHB and DSCP values used above (i.e. 6 and 46) will be used consistently throughout the configuration of the ProCurve switches. The DSCP value used above is in decimal whereas the value used for ProCurve switch configuration later will be in binary (i.e. 101110).

5. Configure the ProCurve 5406zl Switch

This section addresses how to configure the ProCurve 5406zl Switch. The ProCurve 5406zl Switch is used as the core Layer 2/Layer 3 router, enforces QoS policies and supports link aggregation, OSPF and spanning tree.

To configure the ProCurve 5406zl Switch, connect a PC or laptop to the serial port of the ProCurve 5406zl Switch. Run a terminal emulation program with the following configuration:

ƒBits per second: 9600

ƒData bits: 8

ƒParity: None

ƒStop bits: 1

ƒFlow Control: None

TMA; Reviewed:	Solution & Interoperability Test Lab Application Notes	6 of 21
SPOC 7/21/2008	©2008 Avaya Inc. All Rights Reserved.	ProCurve-ACM