Buffalo Technology WYR-G54 manual Troubleshooting, Common Problems, Status LED Lit Red

Page 47

Troubleshooting

Common Problems:

Out of range, client cannot connect to the AirStation.

Configuration mismatch, client cannot connect to the AirStation.

Absence or conflict with the Client Driver.

Conflict of another device with the AirStation hardware.

Status LED Lit Red

Unplug the power for three seconds. Plug the power back in to monitor the DIAG LEDs during start-up.

If any symptoms match section B.1.1, call the Buffalo Tech Support line 24 hours a day, 7 days a week at 866-752-6210or email info@buffalotech.com for USA and Canada only.

Table B.1.1 DIAG LED Activity Table

DIAG LED Display

Time

Description/Action

 

 

 

Continuous Red

Starting

RAM Error Red flash, 2 times Starting Flash ROM

 

 

Error

 

 

 

Red flash, 3 times

Starting

A problem on the wired LAN side

 

 

 

Red flash, 4 times

Starting

A problem on the wireless LAN side

 

 

 

B. 1.2 LEDs Work But Client PC Cannot Connect to Network

47

Image 47
Contents WYR-G54 Table of Contents Table of Contents Table of Contents Introduction AirStation G54 Wireless Cable/DSL Router WYR-G54SOHO/SMB Networking Home NetworkingSystem Requirements AirStation WYR-G54 Package ContentsProduct Views About the AirStation CD Introduction Introduction Installation / SetupSetup Preparation Setup OverviewOpen the Setup Screen Antenna Logging DSL users can now skip to Setup Wizard LaunchInternet Setup Choosing a Connection TypeAutomatic IP Assignment by ISP Setup Wizard SetupCable Connection Options Cable Users can now skip to Setup Wizard CableManual Entry of IP Information DSL Connection Options Setup Wizard DSLPPoE Setup Line Test Setup Wizard Line TestWireless Security Setup Setup Wizard SecurityWEP Setup Wireless SettingsWireless Settings LAN SettingsClient computers may Roam between the AirStations Choosing Clients that can Access LAN or WAN Resources Wireless Security WEP Setup WAN Port Settings WAN Port SettingsDirect Connection Options Advanced SettingsPPPoE Client Options Remote Management When Dyanmic DNS Routing Information Address Translation NAT Address TranslationDemilitarized Zone Client Network Address Translation NAT by Service and DevicePacket Filtering Packet FilteringIntrusion Detector Intrustion Detector FirewallUPnP UPnP ServiceSystem Information Basic Settings Basic SettingsClient Monitor Advanced SettingsDiagnostics DiagnosticsIntrustion Detector Logs possible Log InformationLog Information Save or Restore Settings Restart Restore DefaultsRestore Factory Defaults Firmware Update Table B.1.1 Diag LED Activity Table TroubleshootingCommon Problems Status LED Lit RedOther Problems Changing Client TCP/IP Settings in WindowsDCE Data Communications Equipment GlossaryDsss Direct Sequence Spread Spectrum MHz MegaHertz One million cycles per second ROM Read Only Memory Permanent memory PCI Peripheral Component Interconnect aGlossary Glossary Federal Communication Commission Interference Statement FCC / CE InformationFederal Communication Commission Interference Statement Important NoteEurope EU Declaration of Conformity FCC RF Radiation Exposure StatementFCC / CE Information 1999/5/ΕΚ FCC / CE Information EU Countries intended for use Intended useEU countries not intended for use Warranty Information General Inquiries Contact Information4030 W. Braker Ln. Suite Austin, Texas Tel Fax