Buffalo Technology WYR-G54 manual Choosing Clients that can Access LAN or WAN Resources

Page 24

Wireless Settings

AirStation will not be found unless the speciﬁ c AirStation’s SSID is entered in the client computer manually.

Wireless Radio Enabled - By default the wireless radio is turned on, however by disabling the radio, no wireless communications can take place. Wired connections can continue uneffected though.

Access to LAN - Speciﬁ c clients can be given access to the local network (LAN) by enabling this limita- tion. By default all clients (wired and wireless) have access to the local network resources. Local network resources can include but are not limited to, other computers’ shared ﬁ les, networked printers and scan- ners.

Access to WAN - Speciﬁ c clients can be given access to the Internet (WAN) by enabling this limitation. By default all clients (wired and wireless) have access to the Internet through the WAN port.

Choosing Clients that can Access LAN or WAN Resources

To add users to the access tables, they must have previously connected to the AirStation. Select the clients you wish to limit access to and click Apply.

Clients can be removed from the table at a later time if needed.

Note: Always click Apply to save your changed settings to the AirStation.

24

Image 24

Contents WYR-G54 Table of Contents Table of Contents Table of Contents AirStation G54 Wireless Cable/DSL Router WYR-G54 IntroductionHome Networking SOHO/SMB NetworkingAirStation WYR-G54 Package Contents System RequirementsProduct Views About the AirStation CD Introduction Installation / Setup Setup PreparationSetup Overview IntroductionOpen the Setup Screen Antenna Logging Setup Wizard Launch Internet SetupChoosing a Connection Type DSL users can now skip toSetup Wizard Setup Cable Connection OptionsAutomatic IP Assignment by ISP Setup Wizard Cable Manual Entry of IP InformationCable Users can now skip to Setup Wizard DSL PPoE SetupDSL Connection Options Setup Wizard Line Test Line TestSetup Wizard Security Wireless Security Setup Wireless Settings WEP SetupLAN Settings Wireless SettingsClient computers may Roam between the AirStations Choosing Clients that can Access LAN or WAN Resources Wireless Security WEP Setup WAN Port Settings WAN Port SettingsAdvanced Settings Direct Connection OptionsPPPoE Client Options Remote Management When Dyanmic DNS Routing Information Address Translation Address Translation NATDemilitarized Zone Client NAT by Service and Device Network Address TranslationPacket Filtering Packet FilteringIntrustion Detector Firewall Intrusion DetectorUPnP Service UPnPSystem Information Basic Settings Basic SettingsAdvanced Settings Client MonitorDiagnostics DiagnosticsLog Information Log InformationIntrustion Detector Logs possible Save or Restore Settings Restore Defaults Restore Factory DefaultsRestart Firmware Update Troubleshooting Common ProblemsStatus LED Lit Red Table B.1.1 Diag LED Activity TableChanging Client TCP/IP Settings in Windows Other ProblemsGlossary DCE Data Communications EquipmentDsss Direct Sequence Spread Spectrum MHz MegaHertz One million cycles per second PCI Peripheral Component Interconnect a ROM Read Only Memory Permanent memoryGlossary Glossary FCC / CE Information Federal Communication Commission Interference StatementImportant Note Federal Communication Commission Interference StatementFCC RF Radiation Exposure Statement Europe EU Declaration of ConformityFCC / CE Information 1999/5/ΕΚ FCC / CE Information Intended use EU Countries intended for useEU countries not intended for use Warranty Information Contact Information General Inquiries4030 W. Braker Ln. Suite Austin, Texas Tel Fax