INSTALLING THE
CUTTER
BLADES
Continued
DANGER: Sharp blades!
Most injuries caused by knife blades occur when the cutter has been turned off. Handle blades with care at all times.
●Always lock out power to the cutter before
opening the cutting chamber.
●Always wear
●Always wait until the cutter head has com- pletely stopped before opening the knife guard.
Never attempt to change or work on Blades without first locking out power to the machine.
●When the knife guard is opened, the knife guard switch stops the cutter.
●Two
are in place.
●The STOP button activates a circuit that stops the cutter head.
Installing the Cutter Blades
1 Shut off the main power disconnect and unplug the main power cord when entering the cutter housing. There is a safety interlock on the cutter blade housing that will deactivate the servo amplifier and control system.
2 Remove the screws holding the blades, remove the old blades and insert the new blades. The blade, or blades as the case may be, will fit onto a roll pin or in a machined slot with a blade clamp to squeeze or tighten. Secure the blade.
For more information about choosing the appropriate blade for your material, see the Appendix B.
INSTALLATION | UGE059/1003 |