CONTROL
INSTRUCTIONS
HOME OFFSET
CONTINUED
Raise will increase the value by 1.0. The key can be pressed once for each 1.0 increment required or held down to scroll up. Releasing the key will freeze the value at the last value.
Lower will decrease the value by 1.0. The key can be pressed once for each 1.0 decrement required or held down to scroll down. Releasing the key will freeze the value at the last value.
Numeric keys
Key in the distance desired and press enter. The decimal place is fixed so remember this when entering the value. If you require 15.0 degrees you must key in 150 and then press enter. Keying only 15 will set the distance to 01.5 degrees.
Enter or Delete?
If the keyed in number is correct press the enter key for it to be accepted and return to the Maintenance Area screen. If it is wrong press the delete key and the previous value will reap- pear.
CONTROL
INSTRUCTIONS
OFFSET
EXAMPLE
HOME OFFSET EXAMPLE
With the Cut Enable on/off turned off and the cutter started, entering a new value at the Home Offset screen will initiate a home routine using the new value.
The graphic example above demonstrates the resulting home position with a 15 degree offset.
The acceptableHOME00.OFFSET0TO+45DegrangeRANGEfor .thisISvalue is 00.0 to +45.0 degrees. Making an entry outside of this range generates the following error message on the operator display.
After 5 seconds or if any key is pressed the display returns to the Home Offset
| OPERATION | UGE059/1003 |
