CONTROL
INSTRUCTIONS
LENGTH
SCREEN
CONTINUED
Exit or Prev, if no change is required press Exit or Prev to return to the Main screen.
Raise will increase the preset by 0.010 inch. The key can be pressed once for each 0.010 inches increment required or held down to scroll up. Releasing the key will freeze the preset at the last value then press enter.
Lower will decrease the preset by 0.010 inch. The key can be pressed once for each 0.010 inch decrement required or held down to scroll down. Releasing the key will freeze the preset at the last value then press enter.
Numeric keys
Key in the length required and press enter. The decimal place is fixed so remember this when entering the preset. If you require 24 inches you must key in 24000 and then press enter. Keying only 24 will set the length to 0.024 inches.
Enter or Delete?
If the keyed in number is correct press the enter key for it to be accepted and return to the Main screen. If it is wrong press the delete key and the previous preset will reappear.
CONTROL
INSTRUCTIONS
PRESET TO
RUN SCREEN
PRESETS TO RUN SCREEN
By pressing the soft key located under the word #Prst on any Length Screen,RUNthe4PRESETSvalue for the number of presets to run is available. AdditionalExitinformation on how to access this screen can be found on the multiple preset example in the operator display overview in Appendix E of this manual.
The number shown is the current number of presets to run value, i.e. how many measurement presets and batches to run. The acceptable range for this value is 1 to 4. The cutter will process preset#1/batch#1 then #2 then #3 then #4 and back to #1 continuously. If a 2 is entered only preset/batch 1 and 2 are processed. A cursor will appear in the least significant digit. The user has a choice of ways to adjust this number.
Continued
| OPERATION | UGE059/1003 |