Conair SC-5 manual Control Instructions Batch Screen, Control Instructions Total Screen Continued

Reset Softkey3

Under the counter, on the right is a soft key labeled Reset. Pressing this key will zero the counter.

EXIT or PREV, fixed function keys return the display to the Parts Select screen.

CONTROL

INSTRUCTIONS

TOTAL SCREEN

CONTINUED

BATCH SCREEN

By pressing softkey3 located under the word Batch on the Parts Select Screen, a six-decade Batch counter is available. Additional information on how to access this screen can be foundChangein theBATCHoperator000,000OffdispcslayReset.overview in Appendix E of this manual.

This is typically used to count the pieces required to fill a car- ton, with the product being cut. The batch counter counts up to the batch preset and resets to zero. As the accumulated count reaches the alarm preset the batch pre-warn output-3 energizes then when the batch preset is reached the batch complete output-2 briefly energizes and both outputs turn back off. Sample/Manual cuts are not counted. When enabled the count continues to accumulate even if the batch display is not being viewed. It is also possible to turn this counter off or on.

Change Softkey1

Under the counter, on the left is a soft key labeled Change. Pressing this key displays the Select Batch Area screen. The operator can then choose to set the batch or alarm preset.

On/Off Softkey2

Under the counter near the center is a soft key labeled On or Off. Pressing this key while On is displayed will disable the counter. Likewise pressing this key while Off is displayed enables the counter.

Reset Softkey3

Under the counter, on the right is a soft key labeled Reset. Pressing this key will zero the batch counter.

EXIT or PREV, fixed function keys return the display to the Parts Select screen.

CONTROL

INSTRUCTIONS

BATCH SCREEN

Continued

UGE059/1003 SC-5 SURE CUT Servo Knife Cutter OPERATION 4-7