1
Press the manual cut button and observe the movement of the cutter blade. The cutter head makes a single rotation and the blade moves through the cutter bushings without interference.
CHECKING CUT QUALITY
2
3
Insert a piece of extrudate through the cut- ter bushings.
Press the manual cut button. A single cut is made at the preset blade speed. (This works even if Cut On/Off is off.)
4
Inspect the cut. If necessary, adjust the blade design or blade speed. See All About Cutter Blades, Appendix B.
If you have not already done so, check the cutter hardware, power up the cutter, select cutting mode and blade speed, and make a test cut to check cut quality.
When you are satisfied with cut quality, press the Cut On/Off soft key and on is displayed, automatic operation begins.
When the extrudate is running within tolerance, cut it with a knife or saw and feed it through the cutter bushings.
STARTING THE
SC-5 CUTTER
UGE059/1003 | OPERATION |
