CONTROL
INSTRUCTIONS
FUNCTION
AREAS
CONTINUED
Next or Prev, Pressing Next selects the second Function Area. Pressing Prev returns the display to the first Function Area screen. Pressing Prev from the first Function Area screen returns the display to the active main mode screen.
Menus are a convenient way to access and monitor parameters that do not need to be altered often, i.e. blade speed, blade count, cut mode, repeatability test, min. allowable measure- ment and cuts per minute.
The most frequently used functions for a certain cutting mode are directly available from the main screen for the active mode. For a guide to screen navigation for any active mode see the operator display overview section of this manual for that mode. For information on the Blade and Parts Softkeys see their respective sections covered earlier in this manual.
CONTROL
INSTRUCTIONS
TEST
Continued
TESTPressingOffSOFTKEYsoftDevCPkey000Exit.000two locatedmSReset>under the word Test on the first Function area screen, selects the repeatability tester.
The DevCP repeatability tester displays total deviation time in milliseconds. This time is from a cut being requested until the blade reaches the part. The smallest measured value is sub- tracted from the largest measured value and the resulting devi- ation is displayed on the screen. New data is sampled every consecutive cut. The DevCP repeatability test is available in all
On/Off Softkey1
On the display, on the lower left side is a soft key labeled On or Off. Pressing this key while On is displayed will reset all values and disable testing. Likewise pressing this key while Off is displayed starts the test.
Reset Softkey3
On the display, on the lower right side is a soft key labeled Reset. Pressing this key will reset all test values and start a new test.
Exit or Prev, Pressing Exit, Prev or the Softkey under the word Exit resets all values and disables testing then returns the display to the Function area screen.
| OPERATION | UGE059/1003 |
