ATTENTION:
READ THIS SO NO
ONE GETS HURT
CAUTION: It is always recommend that the main power cord be dis- connected and placed in clear view of the operator or service person- nel while changing blades or ser- vicing the cutter in any capacity.
WARNING: Voltage Hazard
This equipment is powered by
A
Always disconnect and lockout power before opening the electrical enclosure or performing
In order to protect the operator from possible harm from the rotating blade wheel, several safety features are built into this cutter. They include:
Two electric switches make a contact between the side and the clear polycarbonate sliding blade observation windows such that the windows MUST BE CLOSED in order to enable the blade wheel to spin.
●This prevents someone from opening the windows and having the blade wheel spin which can cause serious
injury. Tampering with this safety feature will VOID ANY responsibility for safety.
A proximity switch is positioned on both the upstream and downstream side of the bushing holder. If there are no bushings in either side, the blade will not spin.
●This prevents someone from inserting their hands or fingers in the cutting mechanism while the blade wheel is spinning. Tampering with this feature will also VOID ANY responsibility for safety.
A safety switch is positioned on the bushing holder flip up guard to prevent operation unless fully closed.
●This prevents someone from inserting their hands or fingers in the cutting mechanism while the blade wheel is spinning. Tampering with this feature will also VOID ANY responsibility for safety.
A lockable main power disconnect is provided to pre- vent the possibility of hazardous electrical shock while servicing the main electrical enclosure. (See How to use the Lockout Device, in Section 1)
INTRODUCTION | UGE059/1003 |