Conair SC-5 manual Control Instructions Hold-Off Screen, 4-12, Hold-Off Time Screen, Continued

CONTROL

INSTRUCTIONS

TIME SCREEN

CONTINUED

Raise will increase the preset by 0.010 second. The key can be pressed once for each 0.010 second increment required or held down to scroll up. Releasing the key will freeze the pre- set at the last value then press enter.

Lower will decrease the preset by 0.010 second. The key can be pressed once for each 0.010 second decrement required or held down to scroll down. Releasing the key will freeze the preset at the last value then press enter.

Numeric keys

Key in the time required and press enter. The decimal place is fixed so remember this when entering the preset. If you require 1.5 seconds you must key in 1500 and then press enter. Keying only 15 will set the time to 0.015 seconds.

Enter or Delete?

If the keyed in number is correct press the enter key for it to be accepted and return to the Main Timer Mode screen. If it is wrong press the delete key and the previous preset will reap- pear.

CONTROL

INSTRUCTIONS

HOLD-OFF

SCREEN

HOLD-OFF TIME SCREEN

By pressing the soft key located under the word Time on the Main End Sense Mode Scre n, the preset for the hold-off timer is available. Additional information on how to access this screen can be found in the operator display overview in Appendix E this manual.

Holdoff00000Exit.500sec

The number shown is the current hold-off time preset, i.e. the time interval to ignore the photo eye and avoid false cuts. A cursor will appear in the least significant digit. The user has a choice of ways to adjust this number.

Exit or Prev, If no change is required press Exit or Prev to return to the Main End Sense Mode Screen.

Continued

4-12 OPERATION SC-5 SURE CUT Servo Knife Cutter UGE059/1003