CONTROL
INSTRUCTIONS
BLADE SPEED
SCREEN
CONTINUED
Raise will increase the preset by 1.0. The key can be pressed once for each 1.0 increment required or held down to scroll up. Releasing the key will freeze the preset at the last value then press enter.
Lower will decrease the preset by 1.0. The key can be pressed once for each 1.0 decrement required or held down to scroll down. Releasing the key will freeze the preset at the last value then press enter.
Numeric keys
Key in the time required and press enter. The decimal place is fixed so remember this when entering the preset. If you require 750.0 rpm you must key in 7500 and then press enter. Keying only 750 will set the speed to 075.0 rpm and an error message with the valid range will be displayed.
Enter or Delete?
If the keyed in number is correct press the enter key for it to be accepted and return to the Blade Select or Main Mode Screen. If it is wrong press the delete key and the previous preset will reappear.
CONTROL
INSTRUCTIONS
BLADE COUNT
SCREEN
BLADE COUNT SCREEN
By pressing the soft key located under the word Blade or Count dependingRUN1onBLADESthe current mode, the preset for the blade count is availableExit. Additional information on how to access this screen can be found in the operator display overview in Appendix E of this manual.
The number shown is the current blade count preset, i.e. the number of blades mounted to the cutter head. A cursor will appear in the least significant digit. The user has a choice of ways to adjust this number.
Exit or Prev, if no change is required press Exit or Prev to return to the Blade Select or Main Mode Screen.
Continued
| OPERATION | UGE059/1003 |
