Conair SC-5 Weekly, Monthly, Semi-annual every 6 months, this option. See Cleaning the Blade Tray

●Weekly

❒Cleaning the blade lubrication tray (if the cutter

has	this option). See Cleaning the Blade Tray,
Section 5.

❒Lubricating shafts on optional slide rail system See Cleaning the Blade Tray, Section 5.

PREVENTATIVE

MAINTENANCE

SCHEDULE

● Monthly CONTINUED

❒Checking hardware on the knife guard

Inspect the hardware on the knife guard (fasteners on hinge and the clear blade guard window). Tighten as needed.

❒Checking bushing holder proximity switches Inspect the sets screws which retain the bushing holder proximity switches for tightness. Adjust as needed. See Adjusting the Proximity Switches, Section 5.

❒Checking the draw latch

Inspect the latch on knife guard windows for wear and

Draw Latch

Clear Guard Windows

❒Clean the clear blade guard window

Clean using glass cleaner or plain water. Other materi- als may cause premature loss of clarity or crazing.

●Semi-annual (every 6 months)

❒Inspecting electrical terminals

Check all electrical terminals for tightness; adjust as needed. See Checking Electrical Connections, Section 5.

❒Checking torque on Trantorque coupling device Check the tightness (torque) of the Trantorque coupling device with a torque gauge. This device connects the cutter head to the Micron reducer shaft. See Checking Torque, Section 5.

❒Checking all electrical cables

Inspect all electrical cables for cuts and abrasions.

Replace as needed.

❒Inspecting control panel lights

Check to make sure no LEDs or lights are burned out on the control panel. Replace as needed.

UGE059/1003 SC-5 SURE CUT Servo Knife Cutter MAINTENANCE 5-5