Conair SC-5 manual Checking The Encoder, Check all connections, WARNING Delicate equipment

CHECKING THE ENCODER

Continued

When the encoder is working properly, the encoder LEDs on the control panel light or flicker as the encoder wheel moves and generates signals. If the LEDs do not light when the encoder wheel moves:

1	Check all connections.
	Check the encoder cable for damage. If neces-
2
	sary, replace.
	Check the connector that attaches the cable to
3
	the encoder. Internal wiring may be shorted out if this
	connector is not handled properly.
	Check the encoder itself. There should be no play
4
	in the shaft.

WARNING: Delicate equipment

The encoder is a delicate piece of equipment. Any rough handling can damage fragile parts.

5 If all else fails, contact Conair Customer Service. See Appendix A.

6-14TROUBLESHOOTING SC-5 SURE CUT Servo Knife Cutter UGE059/1003