Buffalo Technology WYR-G54 manual Changing Client TCP/IP Settings in Windows, Other Problems

Page 48

Troubleshooting

If the LEDs indicate that the network is working properly (Power LED is on, Transmit/Receive LED blinks), check the TCP/IP settings of the network.

Changing Client TCP/IP Settings in Windows

Consult the LAN Administrator for TCP/IP settings.

To add or change the TCP/IP Settings:

1.On the Windows task bar click Start.

2.Select Settings, then Control Panel.

3.Double-click on the Network icon to view the Network Properties.

4.From the list of installed components, verify the TCP/IP => wireless LAN adapter protocol is installed.

If the wireless adapter protocol is not yet installed, click the Add button and select the TCP/IP protocol from the list. Refer to Windows Help for more information.

If the wireless adapter protocol is installed, select the protocol and click the Properties button. Verify the parameters match the settings provided by your LAN Administrator. Make changes if necessary, and click OK.

5.When or if prompted, restart your computer.

B. 1.3 Other Problems

Please refer to www.buffalotech.com for further reference materials.

48

Image 48
Contents WYR-G54 Table of Contents Table of Contents Table of Contents AirStation G54 Wireless Cable/DSL Router WYR-G54 IntroductionHome Networking SOHO/SMB NetworkingAirStation WYR-G54 Package Contents System RequirementsProduct Views About the AirStation CD Introduction Installation / Setup Setup PreparationSetup Overview IntroductionOpen the Setup Screen Antenna Logging Setup Wizard Launch Internet SetupChoosing a Connection Type DSL users can now skip toSetup Wizard Setup Cable Connection OptionsAutomatic IP Assignment by ISP Setup Wizard Cable Manual Entry of IP InformationCable Users can now skip to Setup Wizard DSL PPoE SetupDSL Connection Options Setup Wizard Line Test Line TestSetup Wizard Security Wireless Security SetupWireless Settings WEP SetupLAN Settings Wireless SettingsClient computers may Roam between the AirStations Choosing Clients that can Access LAN or WAN Resources Wireless Security WEP Setup WAN Port Settings WAN Port SettingsAdvanced Settings Direct Connection OptionsPPPoE Client Options Remote Management When Dyanmic DNS Routing Information Address Translation Address Translation NATDemilitarized Zone Client NAT by Service and Device Network Address TranslationPacket Filtering Packet FilteringIntrustion Detector Firewall Intrusion DetectorUPnP Service UPnPSystem Information Basic Settings Basic SettingsAdvanced Settings Client MonitorDiagnostics DiagnosticsLog Information Log InformationIntrustion Detector Logs possible Save or Restore Settings Restore Defaults Restore Factory DefaultsRestart Firmware Update Troubleshooting Common ProblemsStatus LED Lit Red Table B.1.1 Diag LED Activity TableChanging Client TCP/IP Settings in Windows Other ProblemsGlossary DCE Data Communications EquipmentDsss Direct Sequence Spread Spectrum MHz MegaHertz One million cycles per second PCI Peripheral Component Interconnect a ROM Read Only Memory Permanent memoryGlossary Glossary FCC / CE Information Federal Communication Commission Interference StatementImportant Note Federal Communication Commission Interference StatementFCC RF Radiation Exposure Statement Europe EU Declaration of ConformityFCC / CE Information 1999/5/ΕΚ FCC / CE Information Intended use EU Countries intended for useEU countries not intended for use Warranty Information Contact Information General Inquiries4030 W. Braker Ln. Suite Austin, Texas Tel Fax