Setup

The setup of the USB Print Server is performed using the following steps:

Connect the USB Print Server into the included AC Adapter power cord,

and attach the power cord to a power outlet.

Connect the included standard patch cable from the USB Print Server to a switch, hub, or router on your network.

Connect the included USB A-to-B cable to the USB Print Server and the USB Printer. Visually inspect all connections and verify that they are secured.

Software Installation- Windows Based PC’s

*Macintosh Procedure on Page 19*

This section describes how to properly install and use the USB Print Server conﬁguration software. Please follow the following steps to properly install the software:

Insert the included CD into a CDROM Drive.

Run the setup.exe program found on the root of the CD. This can be done by browsing to the CD or by going to the ‘Start Menu’, selecting ‘Run...’ , and typing x:\setup.exe (Where x is the drive letter of the CDROM Drive), then press the ‘OK’ button.

The Install Shield Wizard for LPV2 Manager will open up. Press the ‘Next’ button.