Asante Technologies FS4008DS user manual Wall Mounting the FS4004DS

Insert the plastic anchors (supplied) into the drilled holes and gently tap them in with a hammer.

Measure the screw holes on the bottom of the FS4004DS.

Installation

Wall Mounting the FS4004DS

The FS4004DS comes with a wall-mount kit.

▲Important! The FS4008DS cannot be mounted on a wall.

To mount the FS4004DS on a wall, consider the following when select- ing a site for the FS4004DS:

❏Select a site that is free of obstructions from other equipment or devices

❏Place the Switch high enough to easily observe LED indicators and to allow for easy power and cable access

❏Decide whether you want the Switch’s front panel to face either up or down

To mount the FS4004DS on a wall:

1

2 Drill two holes into the wall equalling the same dis- tance as measured in step 1.

▲Important! Do not drill the holes too deep into the wall.

3

4 Insert and turn the screws (supplied) into the plas- tic anchors, leaving a small portion of the screws sticking out.

5

6

Lift the FS4004DS and align the slots on the bottom of the FS4004DS with the screw anchors.

Gently slide the FS4004DS onto the screws.

The FS4004DS wall mounting is complete. The FS4004DS is ready for network connections.

Page 2-6