Asante Technologies 100TX Conﬁguring Network Access Parameters, Network Information table

Page 22

Management

Conﬁguring Network Access Parameters

To conﬁgure and/or manage an AsantéFAST 100 Hub stack over the net- work or via out-of-band access, the hub stack’s management module needs to be properly conﬁgured with network access parameters. These parameters are initially set-up in the management module via the module’s console port; however, some can be modiﬁed using IntraSpec- tion.

To conﬁgure network access parameters:

1 Do not select any item on the Device Page’s front panel image. (This selects the entire hub stack.)

2 Click Network.

The Network Information table appears, similar to Figure 3-9.

3

4

5

Figure 3-9 Network Information table

Click once in the ﬁeld to be edited.

For a description of each ﬁeld, see “Network “ on page 4-9.

▲Important: If you change the IP address, sub- net mask, and/or default gateway, you must reset the stack’s management module. See “Reset- ting a Group or Device” on page 3-20.

Type the new information.

Click Apply.

The network information is edited. Click Refresh to view updated information.

▲Important: If you changed the IP address, you must rediscover the device on your network map using the AutoDiscovery feature. See “Accessing the Device Page” on page 3-1 for instructions.

Page 3-10

Image 22

Contents IntraSpection Personality Modules Copyright Notice Table of Contents Index-i AsantéFAST 100 Hub Personality Module AsantéFAST 100 HubAsantéFAST 100 TX Managed Hub Personality Module Management OptionsServer System RequirementsClient About This Manual Installation Installation Installing a Personality Module Page Accessing the Device ManagementManagement Device Information Device Page ComponentsPersonality Module Information Front Panel Image Components Group NumberingSelecting the Device for Management Selecting an ItemTable Columns Menu ComponentsTables ButtonsConﬁguration Tasks Performing Basic Management FunctionsManagement Tasks Setting Community Strings IntraSpection navigation barSetting Community Strings Conﬁguring Network Access Parameters Network Information tablePage Performing a Software Upgrade Click SoftwareUpdating the Device Click ValidateViewing General Device Information 12 Device Information tableViewing Module Information 13 Modules TableViewing Snmp Agent Information 14 Agent Information tableEnabling/Disabling Ports 15 Port TableDisabling a Group Partitioning a Port Click PartitionResetting a Group or Device 18 Group Reset tableEnabling Traps 20 Agent Information tablePage Deleting a Trap Receiver Entry Setting Alarms Click ThresholdSetting Alarms Deleting an Alarm Viewing Node Summary Information Click Node SummarySetting Port Security Click Port SecuritySetting Port Security Viewing Statistics Table StatisticsGraph Statistics Page Identify SWUpgradeMenu Description Conﬁguration DevicePartition ResetMenu Description Control ThresholdIdentify Device Modules Ports Field Description Admin Status Agent Network SWUpgrade Reset Reset MenuPort Level Group Number PartitionField Description Group Level Board Partition Group Number Port NumberThreshold Field Description Subject Sample TypeDetected Value Field Description Startup EventThreshold Value Rising EventNode Summary Field Description Sampling Interval FramesTooLongErrors the numberObjects Field Description Graph Allowed Address Port SecurityViolation Action Trap Receiver Trap ReceiversField Description Status Community StringPage Technical Support Technical Support HoursPage Index NumericsSee also Index-iii 30,3-31 Major 4-8,4-10 minor 4-8,4-10 Index-vi