Asante Technologies IC3624PWR user manual Preparing for Installation, Unpacking and Inspecting

Page 14

14

3.4 Preparing for Installation

Switches can be mounted in a standard 19-inch equipment rack or on a flat surface. Follow these general precautions when planning your equipment locations and connections.

The site needs the following:

•Centrally located to the devices you want to link

•Near a power outlet.

•Constant temperature within 32° to 104°F (0° to 40°C) and its humidity within 10% to 90%, non-condensing

•Adequate space (approximately 2 in or 5 cm) on all sides for proper air flow

•Accessible for installing, cabling and maintaining the devices

•Clearly visible status LEDs

Additional precautions:

•Keep the front of the chassis free from obstruction and away from the exhaust air of other equipment. Electrical equipment generates heat and the ambient room temperature be enough to cool the equipment to required operating temperatures.

•Make sure twisted-pair cable is always routed away from power lines, fluorescent lighting fixtures and other sources of electrical interference, for example radios and transmitters.

•Make sure that the unit is connected to a separate grounded power outlet that provides 100 to 240 VAC, 50 to 60 Hz, is within 8 ft (2.44 m) of each device and is powered from an independent circuit breaker. As with any equipment, using a filter or surge suppressor is recommended.

3.5 Unpacking and Inspecting

Before you unpack your equipment examine all shipping containers for damage. If any damage has occurred, notify the shipping carrier immediately. Unpack the unit by removing the packing material and lifting it from the protective enclosures. Visually examine the equipment and check the container for parts and accessories. You should have the following items:

•An IntraCore IC3624PWR PoE switch

•Four adhesive foot pads

•A Rack Mounting Kit

•Two brackets

•Four screws for attaching the brackets

•An AC Power Cord

•An RS-232 console cable

Contact your dealer immediately if any item is missing.

IntraCore IC3624PWR Layer 2 PoE Switch with Dual Gigabit

Image 14

Contents IntraCore IC3624PWR IntraCore IC3624PWR Technical SupportTable of Contents Page Page Page Connectivity FeaturesIntroduction Performance Network Management OptionsPorts ManagementManagement Access Overview Network PlanningSnmp Access Management Method Advantages DisadvantagesProtocols Snmp ProtocolSafety Recommendations Hardware Installation and SetupInstallation Overview Environmental Requirements PowerSite Requirements Cooling and AirflowPreparing for Installation Unpacking and InspectingRecommended Tools Installing the SwitchMounting the Switch in a Rack Applying Power Desktop or Shelf MountingConnecting to the Console Port Ethernet CablingWiring Map for Serial Cable Switch’s 9-Pin Serial Port Null Modem PC’s 9-Pin DTE PortTwisted-Pair Devices Connecting Network DevicesConnecting to PCs, Servers, Hubs and Switches Cable GuidelinesNetwork Wiring Connections Interpreting LEDsCombo Ports Connectivity GuidelinesFast Ethernet Ports Cable Labeling and Connection Records Configuring the Switch Connecting to the SwitchDirect Access Page Connection Settings Initial LogonPage Using the Interface General Information MenuIntraCore IC3624PWR Layer 2 PoE Switch with Dual Gigabit Heading Description Basic Configuration MenuAdministration Information Hardware InformationAdministration Configuration Map Main Menu-Basic Configuration Menu-IP Configuration IP ConfigurationSnmp Configuration Map Main Menu-Basic Configuration Menu-SNMP ConfigurationPage Snmp Management Configuration Trap Configuration Port Link Down Trap Port Configuration Map Main Menu-Basic Configuration Menu-System SecurityMap Main Menu-Basic Configuration Menu-Forwarding DB Forwarding DBSntp Configuration Map Main Menu-Basic Configuration Menu-SNTP Configuration ARP TableMap Main Menu-Advanced Switch Configuration Advanced Switch ConfigurationMap Main Menu-Basic Configuration- ARP Table Vlan Management Map Main Menu-Advanced Switch Configuration-VLAN ManagementVlan Table Configuration Map Main Menu-Advanced Switch Configuration-VLAN Management Vlan Port Configuration Map Main Menu-Advanced Switch Configuration-Link Aggregation Link AggregationSet Port Priority Port Monitoring Mstp ConfigurationMap Main Menu-Advanced Switch Configuration-Port Monitoring Page Commands Cist Configuration Rapid Spanning TreeCist Basic Port Configuration Advanced Cist Port Configuration IntraCore IC3624PWR Layer 2 PoE Switch with Dual Gigabit Designated Topology Information Regional Topology Information Access List Configuration ClassifierClassifier Configuration Menu Dscp Classifier Group Profile ActionNo Match Action Out Profile Action Port List Mapping Method Quality of Service ConfigurationPolicy Scheduling Method Map Main Menu-Advanced Switch Configuration-Storm ControlStorm Control 8 802.1 Port Based Access Control NAS IDMap Main Menu-Advanced Switch Configuration-IGMP Snooping Igmp SnoopingShow Igmp Snooping Vlan Filter Table Power over Ethernet Show Router Port TablePoE Port Configuration PoE Global Configuration Statistics Map Main Menu-StatisticsTools Tftp Software UpgradeMap Main Menu-Tools-TFTP Software Upgrade Map Main Menu-ToolsConfiguration File Upload/Download Map Main Menu-Tools-Configuration File Upload/DownloadReboot Type System RebootMap Main Menu-Tools-System Reboot Ping ExecutionSystem Log Map Main Menu-Tools-SystemRun CLI Save ConfigurationMap Main Menu-Tools-Save Configuration to Flash Power and Cooling Problems Appendix a Basic TroubleshootingDiagnosing Switch Indicators InstallationIntraCore IC3624PWR Layer 2 PoE Switch with Dual Gigabit Performance Appendix B SpecificationsPhysical Characteristics Standards L2+ SwitchingManagement Features CompliancesPin Assignments for 10BaseT/100BaseTX Appendix C Cables and Pin AssignmentsTwisted-Pair Cable and Pin Assignments Pin Assignments for 1000BaseT Pin Straight-Through WiringCrossover Wiring Fiber Standards Cable Testing for Existing Category 5 CableAdjusting Existing Category 5 Cabling to Run 1000BaseT Page Appendix D FCC Compliance and Warranty Statements FCC Compliance Statement Important Safety InstructionsIntraCore Warranty Statement Appendix E. Online Warranty Registration