Operational Cautions
Note: The areas with potentially explosive atmospheres referred to above include fueling areas such as below decks on boats, fuel or chemical transfer or storage facilities, areas where the air contains chemicals or particles, such as grain, dust or metal powders, and any other area where you would normally be advised to turn off your vehicle engine. Areas with potentially explosive atmospheres are often but not always posted.
Blasting Caps and Areas
To avoid possible interference with blasting operations, turn off your modem product when you are near electrical blasting caps, or in a blasting area. Obey all signs and instructions.
Operational Cautions | ! | |
Cleaning and Drying Considerations | ||
|
This product is not water proof, and exposing the unit to liquids may result in permanent damage to the unit.
If your modem product interior gets wet, then do not try to accelerate drying with the use of an oven or a dryer as this will damage the modem product and void the warranty. Instead, do the following:
1Immediately power off the modem product.
2Remove SIM card (if so equipped) from modem product.
3Shake excess liquid from modem product.
4Place the modem product in an area that is at room temperature and has good air flow.
5Let the modem product and SIM card dry for 72 hours before powering on the modem product.
If the modem product does not work after following the steps listed above, contact your dealer for servicing information.
Clean the external surfaces of the modem product with a damp cloth, using a mild solution of dishwashing detergent and water. Some household cleaners may contain chemicals that could seriously damage the modem product. Avoid the use of any
29