D-Link DSL-100D manual

Page 26

11. In the Configure Port Usage window, select ‘Dial out only’ and click OK.

12. You are again asked to confirm the selection. Click Continue.

13.Finally the Network window again appears. You will see the PCI Modem has been added to the list of network adapters. Click Close.

14. You need to restart the computer to save the settings changes, click Yes.

22

Image 26
Contents DSL-100D Adsl PCI Modem Page Table of Contents Purpose Before you BeginFeatures System RequirementsDetermine Your Operating System Gather InformationOperating Systems Internet Service Protocol Connection Address and ConfigurationConfiguration Form Adsl Communication SettingsStep Software Installation and Configuration Install Software DriverWindows 98/98SE Driver Installation Page Page Windows 95 Driver Installation Click OK Windows 2000 Driver Installation Page Page Page Windows ME Driver Installation Page Page Windows NT 4.0 Driver Installation Page Page Page Configure Modem Page Configure Modem for Windows Page Page Connect to Internet RFC 2364 PPPoA UsersPage For RFC 1483 and RFC 1577 Users Page Windows 95 and Windows 98 RFC 1483/RFC Windows 2000 RFC 1483/RFC Contacting Technical Support Offices Australia D-LINK AustralasiaJapan Link Japan LED Indicators Modem IndicatorsUninstall the Modem Technical Specifications FCC Warning TrademarksCopyright Statement Limited Warranty HardwareLimitation of Warranties Page Registration Card Print, type or use block letters