Verizon UML290 manual Appendix Specific Absorption Rates SAR

Page 14

Serial/Data Cable

A wire that connects two serial ports carrying data to one another.

Transmission Speed

The rate at which data is sent over a communications line, usually measured in kilobits (kbps).

USB Cable

A wire connecting USB port carrying a data.

USB Port

A connector on a computer to connect peripherals using USB (Universal Serial Bus) protocol.

APPENDIX

SPECIFIC ABSORPTION RATES (SAR)

Maximum: SAR

0.70 W/kg CDMA835 Body

SAR

1.02 W/kg PCS CDMA 1900 Body

SAR

0.60 W/kg WCDMA850 Body

SAR

0.96 W/kg WCDMA1900 Body

SAR

0.51 W/kg GPRS850 Body

SAR

1.03 W/kg GPRS1900 Body

THIS MODEL PHONE MEETS THE GOVERNMENT’S REQUIREMENTS AND EUROPEAN UNION (EU) STANDARDS FOR EXPOSURE TO RADIO WAVES.

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg* and EU standards is 2.0 W/10kg.

Tests for SAR are conducted with the phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. Before

a phone model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this model phone when tested for use at the when worn on

24

 

25

 

Image 14
Contents Page Hardware Before Using UML290 ChapterProduct Overview Before Using UML290Introduction to Wireless UML290 USB Modem WHAT’S Inside the Product PackageConfiguration Product FeaturesBefore Using UML290 Product Handling Installing UML290 PrecautionsRecommended System Requirements PrecautionsInstalling UML290 Installing the 4G SIM Card Removing the 4G SIM CardInstalling Vzaccess Manager Installing UML290 Inserting and Removing UML290Regulatory Safety Information USB Modem Extension Cable AccessoryRegulatory Notices Operating ConditionsSafety Precautions Appendix GlossaryGlossary AppendixAppendix Specific Absorption Rates SAR Safety Information for RF Exposure Body Worn OperationAppendix Declaration of Conformity R & TTE Radio
Related manuals
Manual 16 pages 24.27 Kb