Nextel comm IR1200 manual Connect Antenna Cable, Connect Data Cable

Vehicle Installation

1Connect the male end of the ignition cable to the 4-prong connector labeled IGNITION on the modem.

2Connect the free end of the ignition cable to a vehicle circuit that provides 12VDC when the vehicle is running or in ACC, and no 12VDC when the vehicle is OFF or not in ACC.

Connect Antenna Cable

The following table describes the steps for connecting the antenna cable to the modem:

1Insert the male end of the modem antenna cable to the connector labeled MODEM ANT on the modem. (Use only an approved antenna – see list of Approved Antennas on page 22.)

2Insert the male end of the GPS antenna (optional) cable to the connector labeled GPS ANT on the modem. (Use only an approved antenna – see list of Approved Antennas on page 22.)

Connect Data Cable

The iR1200 modem can be connected to the host DTE equipment using a standard “straight through” 9-pin male to a 9-pin female serial cable.

The following step describes how to connect the data cable:

Connect the 9-pin male end of the cable to the iR1200 communication connector and the 9 pin female end of the cable to the data terminal equipment (DTE).

RFM-4200-5015 Rev1 27