Nextel comm IR1200 manual Diagnostic Port

Page 52

iR1200 Modem

What’s the

What it means:

How to Resolve:

Problem?

 

 

 

 

 

Modem will not

The wiring to the

power up or

modem may not be

down

connected properly.

Check the ignition sense wiring to be sure that it is connected.

Verify that the diagnostic port is plugged in correctly.

Check LED status to see if the modem is communicating.

NOTE: The Status LED remains red for up to 3 minutes after power is applied to the iR1200 or immediately after the Reset button is pressed.

Diagnostic Port

The diagnostic port located on the front panel of the iR1200 modem (see Figure 9 on page 39) is used to retrieve data from the modem that will help to analyze and diagnose possible communication issues.

The following table describes steps to connect to the diagnostic port:

1Insert the 9-pin male end of a serial signal cable into the RS- 232 connector labeled DIAGNOSTIC PORT of the modem’s rear panel and tighten the screws.

2Connect the other end of the serial signal cable to a serial COM port on the back of your computer or mobile device and tighten the screws.

44

nextel.com

Image 52
Contents Installation Guide Page Table of Contents Vehicle Installation Table of Contents Please Read Safety Notice on Before using the iR1200 Modem Safety NoticeModem Power Wiring Diagram Level IR1200 Modem FCC Compliance Declaration of ConformityNextel.com Box Contents Before You Begin InstallationRequired Installation Components Stationary Installation Required Accessories DescriptionNextel.com Using This Guide IntroductionWelcome to Nextel Nextel CoverageNextel Customer Care Overview General OverviewModem Operating Modes Modem ConfigurationsIR1200 Modem IR1200 GPS-Enabled Modem Rear Panel of iR1200 Rugged ModemNextel.com Before You Start Installing Installation PreparationInstallation Planning Modem Dimensions Planning Modem LocationDimensions of iR1200 GPS-Enabled Modem Planning Antenna Location Planning Cable LayoutInstallation Tools Serial Cable RoutingNextel.com Vehicle Installation Mounting the Modem Installation StepsSelect Modem Location Mounting the Antennas Mount the ModemSelect Antenna Location Approved AntennasMount the Antennas Route and Connect Cables Approved CableRoute and Connect Power Cable Mobile Data ComputerModem Power Wiring Diagram Level Route and Connect Ignition Cable Approved CableConnect Antenna Cable Connect Data CableNextel.com Stationary Installation Mounting the Modem Mounting the Antennas Select Antenna Location Stationary Installation Connect Power Cable Approved CablesConnect Antenna Cables Connect Data CablesNextel.com Powering Up the Modem Verifying InstallationPowering Up Vehicle Installation Communication Indicators Powering Up Building InstallationSignal Color Indication Circuit Switched Data Packet DataTroubleshooting Common ProblemsConnector on Troubleshooting Diagnostic Port HyperTerminal Setup Connection Description screen appearsNextel.com Diagnostic Menu None or Hardware for Flow controlCommand Action Reply Rssi Imei Unsolicited Firmware Updates Nextel.com You are safe to use the modem Nextel.com Safety Notice Safe and Efficient Operation GuidelinesExposure to Radio Frequency Energy Medical and Personal Electronic DevicesHearing Aids Interference with Other Electronic DevicesOther Medical Devices Copyright and Trademark Nextel.com This page intentionally left blank Nextel.com Index Packet Data · 7
Related manuals
Manual 122 pages 36.58 Kb