Superior SS2000MD4 installation instructions Safety

Page 3

Danaher Motion Superior Electric

Safety

Safety symbols used in this manual are:

Warning Alerts users to potential physical danger or harm. Failure to follow warning notices could result in personal injury or death.

Caution Directs attention to general precautions, which if not followed, could result in personal injury and/or equipment damage.

Note Highlights information critical to your understanding or use of the product.

Instructions

Only qualified personnel should install or perform servicing procedures on this equipment. Do not operate the unit without the enclosures in place as voltage present in this unit can cause serious or fatal injury.

Before performing any work on the unit, allow at least five minutes for the capacitors to discharge fully.

Voltage is present on unprotected pins when unit is operational.

The "PWR ON" LED must be off for approximately 30 seconds before making or breaking the motor connections.

Motors powered by these drives may develop extremely high torque. Disconnect AC power to these drive before doing any mechanical work.

This unit is designed for 115 VAC input only (see Section 4.2,

Electrical Specifications).

Warranty And Limitation Of Liability

Danaher Motion (the "Company") warrants to the first end user purchaser (the "purchaser") of equipment manufactured by the Company that such equipment, if new, unused and in original unopened cartons at the time of purchase, is free from defects in material and workmanship under normal use and service for a period of one year from date of shipment from the Company's factory or a warehouse of the Company in the event that the equipment is purchased from the Company or for a period of one year from the date of shipment from the business establishment of an authorized distributor of the Company in the event that the equipment is purchased from an authorized distributor.

THE COMPANY'S OBLIGATION UNDER THIS WARRANTY SHALL BE STRICTLY AND EXCLUSIVELY LIMITED TO REPAIRING OR REPLACING, AT THE FACTORY OR A SERVICE CENTER OF THE COMPANY, ANY SUCH EQUIPMENT OR PARTS THEREOF WHICH AN AUTHORIZED REPRESENTATIVE OF THE COMPANY FINDS TO BE DEFECTIVE IN MATERIAL OR WORKMANSHIP UNDER NORMAL USE AND SERVICE WITHIN SUCH PERIOD OF ONE YEAR. THE COMPANY RESERVES THE RIGHT TO SATISFY SUCH OBLIGATION IN FULL BY REFUNDING THE FULL PURCHASE PRICE OF ANY SUCH DEFECTIVE EQUIPMENT. This warranty does not apply to any equipment which has been tampered with or altered in any way, improperly installed or has been subject to misuse, neglect or accident.

SS2000MD4

3

400030-043 Rev G

Image 3
Contents Rev G Copyright Information Safety Danaher Motion Superior Electric Table of Contents Using this Manual Product FeaturesIntroduction Failure to do this Results in a Shock Hazard Express Start UPMounting Installation GuidelinesTerminal Locations Terminal Locations and AssignmentsMotor Connections Motor Wiring Configurations Power Input Environmental SpecificationsMechanical ElectricalMotors for USE with the SS2000MD4 TRANSLATOR/DRIVE Step Resolution Current SettingsSignal Specifications Signal DescriptionsTiming Requirements Indicator LightsMotor Performance Torque Versus Speed CharacteristicsTypical Torque Versus Speed Curves Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 Danaher Motion Superior Electric SS2000MD4 General System CheckingAppendix a Troubleshooting Electrical Interference ProblemsCustomer Support