Caller ID Scheme | The GXW410x supports 5 different types of schemes: | |
| 1. | Bellcore (US standard) |
| 2. | ETSIFSK during ringing |
| 3. | ETSIFSK prior to ringing with DTAS |
| 4. | ETSIFSK prior to ringing with LR |
| 5. | ETSIFSK prior to ringing with PR |
| 6. | ETSIDTMF during ringing |
| 7. | ETSIDTMF prior to ringing with DTAS |
| 8. | ETSIDTMF prior to ringing with PR |
| 9. | ETSIDTMF prior to ringing with PR |
| 10. | SIN 227 BT |
| 11. | NTT (Japanese standard) |
| Please check with your PSTN service provider (or traditional PBX specs) for which caller ID | |
| scheme they/it support. If you are not sure about which to use please refer to Table 10 (FXO | |
| Lines Test Tab Definition). This tool will run an automated test to determine the proper Caller ID | |
| Scheme so the gateway can properly detect the Caller ID. | |
| Similarly | to the cases explained above we can specify a caller ID scheme for each channel |
| independently. | |
Caller ID Transport | Default is “relay via From header”. You may also select : | |
type | “relay via P_Asserted_Identity header” | |
| “Disable” : Caller ID feature will be disabled. | |
| “Send anonymous” : All calls forwarded to VOIP end will be sent as anonymous. | |
T.38 Setting | This setting allows you to make several options related to facsimile. | |
| You can select the method: T.38 or Pass through (G711) | |
| You can select the fax transmission rates (2400/4800/7200/9600/12000/14400bps) | |
| You can enable or disable ECM (Error Checking Mode) | |
|
|
|