STUN Server | IP address or Domain name of the STUN (Simple Traversal of UDP through NATs) server. |
Firmware | This radio button will enable GXW410x to download firmware or configuration file through either |
Upgrade & | TFTP or HTTP. |
Provisioning |
|
Via TFTP Server | If selected, the GXW410x will attempt to retrieve new configuration file or new code image from the |
| specified TFTP server at boot time. It will make up to 5 attempts before timeout and then it will start |
| the boot process using the existing code image in the Flash memory. If a TFTP server is |
| configured and a new code image is retrieved, the new downloaded image will be verified and then |
| saved into the Flash memory. |
| Note: Please do NOT interrupt the TFTP upgrade process (especially the power supply) as this will |
| damage the device. Depending on the network environment this process can take up to 25 or 30 |
| minutes. |
Via HTTP Server | The URL for the HTTP server used for firmware upgrade and configuration via HTTP. |
| For example, http://provisioning.mycompany.com:6688/Grandstream/ |
| Here “:6688” is the specific TCP port that the HTTP server is listening at, it can be omitted if using |
| default port 80. |
| Note: If Auto Upgrade is set to No, GXW410x will only do HTTP download once at boot up. |
Firmware Server | IP address or domain name of firmware server. |
Path |
|
Config Server | IP address or domain name of configuration server. |
Path |
|
Firmware File | Default is blank. If configured, GXW400X will request firmware file with the prefix. This setting is |
Prefix | useful for ITSPs. Enduser should keep it blank. |
Firmware File | Default is blank. Enduser should keep it blank. |
Postfix |
|
Config File | Default is blank. Enduser should keep it blank. |
Prefix |
|
Config File | Default is blank. Enduser should keep it blank. |
Postfix |
|
Allow DHCP | Default value is No. If set to Yes, configuration file will originate from the DHCP server. |
Option 66 to |
|
override server |
|
Automatic | Choose Yes to enable automatic upgrade and provisioning. In “Check for new firmware every” |
Upgrade | field, enter the number of minutes to enable GXW410x to check the server for firmware upgrade or |
| configuration. When set to No, GXW410x will only do upgrade once at boot up. Other options are: |
| “ Always check for New Firmware.” |
| “ Check New Firmware only when F/W pre/suffix changes” |
| “ Always skip the Firmware check” |
Authenticate | If set to Yes, configuration file is authenticated before acceptance. This protects the configuration |
Conf File | from an unauthorized change. |
|
|