Telular SX4e TDMA Antenna Location and Setup, Optional Wall-Mount Installation

INSTALLATION

Antenna Location and Setup

The Phonecell SX4e comes with a standard spike antenna - See Figure 1. The Phonecell SX4e comes with a standard spike antenna (TNC). For optimal signal strength, choose an antenna loca- tion that is above ground and as close to windows (or exterior walls) as possible - See Figure 2. Cellular signal strength is displayed by the Received Signal Strength Indicator (RSSI) LED on the unit - See the How to Use the LED Status Indicators section of this guide.

1)Connect the antenna to the SX4e - see Figure 1.

2)Finger-tighten the antenna; do not over-tighten.

Standard Antenna

TNC

Antenna

Connector

Figure 2 - For optimum signal strength, locate the unit near a window with the antenna pointed upward.

Figure 1 - SX4e antenna installation.

Optional Wall-Mount Installation

After you’ve selected a location and made all the necessary connections and adjustments, your SX4e is ready for wall-mounting.

1)To mount the Phonecell SX4e on a wall, mark two hole locations 166 mm (6-17/32 inches) apart. These hole locations match the mounting hooks on the back of the unit - see Figure 3.

2)Install the screws (not supplied), leaving a gap (approximately 3mm (1/8 inches)) between screw head and wall.

3)Mount the FWT onto the screws - see Figure 4.

166 mm (6-17/32 inches)

Figure 3 - Mounting hooks for	Figure 4 - Mount the SX4e onto the screws in
optional wall mounting.	the wall.

SX4e TDMA 800 • SX4e Tri-Mode 4 Technical Manual