WARNING
❏To prevent fire or shock hazard, do not expose your notebook computer to rain or moisture.
❏To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.
❏Never install modem or telephone wiring during a lightning storm.
❏Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
❏Never touch uninsulated telephone wire or terminals unless the telephone line has been disconnected at the network interface.
❏Use caution when installing or modifying telephone lines.
❏Avoid using the modem during an electrical storm.
❏Do not use the modem or a telephone to report a gas leak in the vicinity of the leak.
❏A socket outlet should be as close as possible to the unit and easily accessible.
AVERTISSEMENT
❏Pour prévenir tout risque d’incendie ou d’électrocution, garder cet appareil à l’abri de la pluie et de l’humidité.
❏Pour prévenir tout risque d’électrocution, ne pas ouvrir le boîtier. Confier l’entretien de cet appareil exclusivement à un personnel qualifié.
❏L’appareil doit être le plus près possible d’une prise murale pour en faciliter l’accès.
Regulatory Information
Declaration of Conformity
Trade Name: SONY
Model No:
Responsible Party:
Sony Electronics Inc.
Address:
1 Sony Drive
Park Ridge, NJ 07656
Telephone No.:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
❏Reorient or relocate the receiving antenna.
❏Increase the separation between the equipment and the receiver.