Sony MZ-E800 service manual Main Board, OP Service Assy LCX-2E

MAIN BOARD

2 bracket (B) block assy

1 screw (1.4), MI

	Note: In disconnecting the solder
4 boss	on the terminal board (minus)
	side, take care not to allow
	the soldering iron to touch
	the open/close detect
5 bracket (A)	switch (S809).
	6 Remove the two solders of
	battery terminal (plus) assy and
7 case, battery	terminal board (minus).
open/close detect switch
(S809)
bracket (A)
b	1 three screws (1.4), MI
a	8 MAIN board
A	3 three screws (1.4), MI

MAIN board

Note: In mounting the bracket (A) on the MAIN board, let the part a through under the MAIN board in arrow A direction, and then insert the part b into the MAIN board.

OP SERVICE ASSY (LCX-2E)

5 bearing (N)	3 two screws
7 OP service assy	6 screw block assy, lead
(LCX-2E)
	4
	1 washer (0.8-2.5)
	2 gear (SA)

– 10 –