Sony MZ-E800 service manual Playback

MZ-E800

6-5. SCHEMATIC DIAGRAM – MAIN Board (1/4) – • See page 37 for Waveforms. • See page 38 for IC Block Diagram.

Note on Schematic Diagram:

•All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums.

•All resistors are in Ω and 1/4 W or less unless otherwise specified.

•% : indicates tolerance.

Note: The components identified by mark 0or dotted line with mark 0are critical for safety.

Replace only with part number specified.

(Page 31)

(Page 33)

(Page 35)

(Page 36)

• A : B+ Line.	• Waveforms are taken with a oscilloscope.
• Power voltage is dc 1.5V and fed with regulated dc power		Voltage variations may be noted due to normal produc-
supply from battery terminal.		tion tolerances.
• Voltages and waveforms are dc with respect to ground in	•	Circled numbers refer to waveforms.
playback mode.	•	Signal path.
no mark : PLAYBACK		E : PLAYBACK

∗: Impossible to measure

•Voltages are taken with a VOM (Input impedance 10 MΩ ). Voltage variations may be noted due to normal produc- tion tolerances.

– 29 – – 30 –