Sony MZ-E800 service manual A n u a l, Configuration of Test Mode, Manual Mode

Configuration of Test Mode

[Test Mode $Display Check Mode%]

Press the [VOL +] key

[Manual Mode]

Press the x key

[Servo Mode]

[Audio Mode]

[Power Mode]

[OP Alignment Mode]

Press the . or [VOL --]key

[Overall Adjustment Mode]

Press the x key

press the [DISPLAY] key

[Self-Diagnosis Display Mode]

Press the x key

Press the [DISPLAY] key

for several seconds (about 3 seconds).

[Key Check Mode]

Quit the key check

Manual Mode

Mode to adjust or check the operation of the set by function. Normally, the adjustment in this mode is not executed. However, the Manual mode is used to clear the memory and power supply/charging adjustments before performing automatic adjustments in the Overall Adjustment mode.

• Transition method in Manual Mode

1.Setting the test mode (see page 12).

2.Press the [VOL +] key activates the manual mode where the LCD display as shown below.

Remote commander LCD display

000M a n u a l

3.During each test, the optical pick-up moves outward or in- ward while the N > or . key is pressed for several seconds respectively.

4.Each test item is assigned with a 3-digit item number;

100th place is a major item, 10th place is a medium item, and unit place is a minor item.

				[VOL +] key:100th place of item number
[Major item switching]						increase.
				[VOL --]key:100th place of item number
						decrease.
	N	key		x key
	>
					[VOL +] key:10th place of item number
[Medium			item switching]			increase.
					[VOL --]key:10th place of item number
	N	key		x key		decrease.
	>
					N	key: Unit place of item number
[Minor item				switching]
					>	increase.

[Adjusted value variation]

[VOL +] key:Increases the adjusted value

[VOL --]key:Decreases the adjusted value

[Adjusted value write]

X key: When adjusted value is changed:

Adjusted value is written. When adjusted value is not changed:

That item is adjusted automatically.

– 13 –