Dell EMC AX4-5I manual Support.microsoft.com

Page 45

Table A-1. General Cluster Troubleshooting (continued)

Problem

Probable Cause

Corrective Action

 

 

 

 

The cluster network

Configure the Internet

 

name is not

Connection Firewall to allow

 

responding on the

communications that are

 

network because the

required by MSCS and the

 

Internet Connection

clustered applications

 

Firewall is enabled on

or services.

 

one or more nodes.

For more information, see

 

 

 

 

Microsoft Knowledge Base

 

 

article KB883398 at the

 

 

Microsoft Support website at

 

 

support.microsoft.com.

 

 

 

You are prompted to

The TCP/IP

The node-to-node network and

configure one network

configuration

public network must be assigned

instead of two during

is incorrect.

static IP addresses on different

MSCS installation.

 

subnets.

 

 

 

 

The private (point-to-

Ensure that all systems are

 

point) network is

powered on so that the NICs in

 

disconnected.

the private network

 

 

are available.

 

 

 

Using Microsoft

Normal. Some

Dell strongly recommends that

Windows NT® 4.0 to

resources in Windows

you use Windows XP

remotely administer a

Server 2003 are not

Professional or Windows Server

Windows Server 2003

supported in

2003 for remote administration

cluster generates error

Windows NT 4.0.

of a cluster running Windows

messages.

 

Server 2003.

Troubleshooting

45

Image 45
Contents Hardware Installation and Troubleshooting Guide April Contents Installing the Microsoft iSCSI Cluster Configuration OverviewIntroduction IntroductionCluster Hardware Requirements Cluster SolutionCluster Nodes Cluster Node Requirements Component Minimum RequirementIdentical Cluster Storage Cluster Storage RequirementsRequirement Ethernet Switches Dedicated to iSCSI Supported Cluster ConfigurationsNICs Dedicated to iSCSI Direct-Attached ClusterPrivate network ISCSI connections Storage system ISCSI SAN-Attached ClusterEthernet switch Storage system Other Documents You May NeedPrivate network Page Cabling Your Cluster Hardware Cabling the Power SuppliesCabling the Mouse, Keyboard, and Monitor Cabling Your Cluster HardwareOne AC PDU not shown Cabling Your Cluster for Public and Private Networks Cabling the Public Network Network Connections DescriptionPrivate network Cluster node Cabling the Private Network NIC TeamingPrivate Network Hardware Components and Connections Method Cabling Storage for Your Direct-Attached Cluster Cabling the Storage SystemsCabling Your Cluster Hardware Gigabit Ethernet Cabling Storage for Your iSCSI SAN-Attached ClusterPorts AX4-5i storage arrayStorage system Cabling Your Cluster Hardware Public network Private network Gigabit Ethernet switch Storage systemCabling Your Cluster Hardware AX4-5i storage system Page Storage systems Obtaining More InformationPreparing Your Systems for Clustering Cluster Configuration OverviewPreparing Your Systems for Clustering Installation Overview Installing the Microsoft iSCSI Software Initiator Installing the iSCSI NICsModifying the TCP Registry Settings Installing EMC PowerPathStart the Registry Editor. a Select Start→ Run Configuring the Shared Storage System System Software window, click Upgrade Software Preparing Your Systems for Clustering Configuring the iSCSI Initiator using iSNS Preparing Your Systems for Clustering Network Interfaces NICs window On the cluster node Open the Navisphere Server Utility Configuring the iSCSI Initiator without iSNSApply Page Installing and Configuring a Failover Cluster Preparing Your Systems for Clustering Troubleshooting TroubleshootingSupport.microsoft.com Support.microsoft.com Minimum value Check all cable connectionsServices window Click ServicesCluster Services Window, click the RecoverySupport.microsoft.com Public IP Address Private IP Address Cluster Data Form Cluster Data FormNumber of Attached DAEs Virtual Disks ISCSI Configuration Worksheet ISCSI Configuration Worksheet Storage systems, 25 connecting to one shared storage IndexIndex Mscs