Dell R220 owner manual Troubleshooting The System Battery

3.Ensure that the following components are properly installed:

–Cooling shroud

–Expansion-card risers (if present)

–Expansion cards

–Power supply(s)

–Cooling-fan assembly (if present)

–Cooling fans

–Processor(s) and heat sink(s)

–Memory modules

–Hard-drive carriers

–Hard-drive backplane

4.Ensure that all cables are properly connected.

5.Close the system.

6.Run the appropriate diagnostic test. For more information, see Using System Diagnostics.

If the tests fail, see Getting Help.

Troubleshooting The System Battery

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

NOTE: If the system is turned off for long periods of time (for weeks or months), the NVRAM may lose its system configuration information. This situation is caused by a defective battery.

1.Re-enter the time and date in the System Setup.

2.Turn off the system and disconnect it from the electrical outlet for at least one hour.

3.Reconnect the system to the electrical outlet and turn on the system.

4.Enter the System Setup.

If the date and time are not correct in the System Setup, check the SEL for system battery messages.

If the problem persists, see Getting Help.

NOTE: Some software may cause the system time to speed up or slow down. If the system seems to operate normally except for the time kept in the System Setup, the problem may be caused by software rather than by a defective battery.

70