Dell dell power vault md3200 and md3220 storage arrays manual Storage array, Password, Ms or less

LED Indicators (continued)

RAID controller module	Six single-color LEDs:
	• One battery fault
	• One cache active
	• One controller fault
	• One controller power
	• One system identification
	• One management Ethernet activity
	Six two-color LEDs:
	• Four SAS IN link or fault
	• One SAS OUT link or fault
	• One management Ethernet link speed
Switch
System identification button	Located on the front control panel. This button is
	used to locate a system within a rack.
Enclosure mode switch	Located on the front of the system. This switch is
	not applicable to the PowerVault MD3200 series
	storage array.
Password reset switch	Located on the back-panel of the RAID controller
	module. This switch is used to reset the storage array
	password.

Power Supplies

AC power supply (per power supply)

Wattage	600 W
Voltage	100–240 VAC (8.6 A–4.3 A)
Heat dissipation	100 W
Maximum inrush current	Under typical line conditions and over the entire
	system ambient operating range, the inrush current
	may reach a maximum of 55 A per power supply for
	10 ms or less.

14

Getting Started With Your System