Chapter 6 - Basic Configuration Guide | 21 |
|
|
Suggested for IPX
You may want to set your own network numbers, rather than using the autoconfigured values. You may also want to turn off unused frame types.
CV: Use the IPX Routing: Ethernet 0 Dialog Box.
TB: Use configure and set keywords in the IPX Ethernet 0 (and/or Ethernet 1)section.
WAN Interface Configuration
In order to use a WAN interface, you may first need to set some phys- ical parameters and then set up the link and protocol parameters.
There are differences between the capabilities of the
Internal T1 CSU/DSU (WAN 0) Physical Communications Settings
Required for Dedicated Line Operation
No changes from the default values are required for standard operation over a full T1. The default values are listed in Appendix A.
Suggested for Dedicated Line Operation
Changing to fractional T1, different coding or framing, etc., may be required for a particular installation.
CV: Use the Physical Configuration: WAN 0 Dialog Box.
TB: Use configure and the T1 Interface WAN 0 section.
RS-232 (WAN 1) Physical Communications Settings
You may need to set the baud rate, sync/async operation, and other physical communications parameters for the WAN interface. These parameters will depend on the line communications device you are using.
Note: Frame Relay is presently supported in the MicroRouter 1270i vonly via synchronous operation. An external clock signal is generated for Frame Relay.